Home > Support > Virtual Private Network

SmartRG SR506N Installation Guide

SmartRG SR506N Box content

The SmartRG SR506N gateway box should contain:

  1. A modem, with 2 antennas
  2. A PSU (Power Adapter) with the correct socket
  3. 1 or 2 x RJ11 <-> wall socket cable, to connect the modem to the DSL port
  4. An RJ45 Ethernet cable, suitable for FastEthernet connections

SmartRG SR506N Physical installation

  1. Connect the SmartRG SR506N gateway VDSL2 WAN port to a wall socket (1), use provided country kit adapter, if necessary
  2. Connect your computer to the SmartRG SR506N gateway’s LAN port via a supplied Ethernet cable (2)
  3. Plug the power adapter to the power outlet and connect other end of the cable to the Power port of the SmartRG SR506N gateway (3)
  4. Turn on the SmartRG SR506N gateway by pressing the On/Off button; DSL LED must be lit
  5. Configure your network with the Technical details provided in Order Completion e-mail
  6. Start your computer. You should be able to browse the Internet instantly

Gateway is now automatically being set up to connect to the Internet. This process may take a few minutes to complete before begin able to log to Internet applications (browser, email, etc.)

Notes:

Image

LED indications:

On top of the SmartRG SR506N gateway, there are several LEDs. In the Bridge mode it is normal that the Internet LED is off.

Image

Button Legend

The SmartRG SR506N gateway back, side panel and top panel show buttons. Refer to the below table for legend.

Image Image Image